How Long Does A Well Pump Last Water Well Pump Replacement?
If you are asked to single out the top 3 most important appliances in your household, a well pump is definitely going to be among them. The backbone of your house, well pump provides you with the constant water supply for almost all household chores.
Now, if you are wondering how long your well pump will last before you need to get it replaced or what are the obvious signs that your well pump needs to be checked by a service provider for water well pump replacement in Winnemucca, you are at the right place. Let’s dive in.
How Long Does A Water Well Pump Last Before It Needs To Be Replaced?
A water well pump lasts between 8 to 15 years on an average as reported by most households, However, with regular maintenance and some much-needed time, love and care, it can last as long as 20 to 30 years.
As a homeowner, you must have had your water well pump for a few years now. But how to determine if it’s the right time to get it replaced?
Signs That Your Water Well Pump Needs To Be Replaced
Here’s a list of all the visible signs that your pumps need immediate assistance from a water well service in Mammoth Lakes, CA.
Little to no water
The most prominent sign that your well pump is malfunctioning is that there is no water coming out. If you find little to no water at all when you turn on a faucet, a tap, or flush a toilet, it is a clear indication that something is wrong with your water well pump. You can look into the obvious causes to rule out any other issue, but if it persists, you might want to consult a service for water well pump replacement in Winnemucca.
Methods for troubleshooting-
- Thoroughly check your circuit breaker to make sure that the well is powered on. For that you need to first turn the pump off, reset the breaker, and then turn it back on.
- You need to reset if the pressure tank and the tank that stores the water pulled from the well have shut off.
- If there is a plumbing failure, such as a pipe breaking, it can not just lead to a flooded yard but also overwork your pump. So check for any such leaks and take the required measures.
Drastic decrease in the water pressure.
This is another significant sign. If you turn on your water supply and notice a visible decrease in your typical water pressure, it is a sign that your water well pump is not able to draw as much water as before and is probably beginning to fail.
However, it could also be because of a small water well pump and an addition of a new bathroom, dishwasher installation or large water heater has made it too small to meet all the water requirements. In any case it is necessary to reach out to a water well service in Mammoth Lakes, CA.
Air is coming out from the faucets.
Imagine turning on the faucet, and you are met with not just an unsteady flow of water but also air bubbles coming through the pipes. The inconsistent flow of water is a major sign that the pump is not able to pull water up and is instead pulling in air. If not treated immediately, your water well pump will probably fail altogether.
A constantly working water well pump
If your well pump is working overtime and operating continuously, it is a clear sign that it needs to be replaced or repaired. In addition, if you have an above-ground jet pump system, you should prime the intake pipe since the overworking can be caused by a leak in the suction line. This means it needs to have water in the jet system to generate the suction that is needed to draw water up and into the water line.
Failure to do this can leave the pressure control switch useless, the pipe with a leak, or the pump with extensive wear and tear.
The well water is dirty.
If your water has either a metallic or egg-ish smell or taste it is just the minerals in your well and there is nothing to worry. However, if the water is dirty, sandy, or filled with sediments, it’s absolutely necessary to get it fixed immediately since the source might be your water well pump.
This happens when the pump is too large for your well and hence, it ends up pulling silt and dirt from the bottom, and needs to be replaced by water well service in Mammoth Lakes, CA.
Looking for Certified Professionals for Your Water Well Pump-Related Issues? Bruce Mackay Pump and Well Services is Here To Help.
Be it the harsh winters or the scorching hot summers, we offer only the highest quality service to match your expectations. Not just well-trained and certified, our experts are also well-versed with the latest equipment and technology to solve all your well-related problems such as Water Well Drilling and Water Well Testing.
Since 1981, Bruce Mackay has been committed to making your water consumption easier and better. That is what makes us the best water well service in Mammoth Lakes, CA. So don’t wait up- contact us today!
